【已结帖】Ai-M61-32S-Kit开发板在arduino环境下不能正常下载

在vscode下小安派SDK可以正常编译和下载程序



但是在arduino环境下安装bouffalolab开发板，想要下载一个blink点灯验证一下，结果不好用。。。。
提示[All Success]应该是下载成功了，但是有一个警告"Warning: No input file to program to flash"。
看起来像是固件没有成功下载到开发板里，不知道问题出在哪里，有没有知道的大佬请教一下，谢谢！


Arduino IDE 1.8.19
bouffalolab 1.0.5

哈哈，已经解决
是因为权限问题，改为使用管理员权限启动arduino就OK了

多谢了，我也有这个问题

WIN10
Arduino IDE 2.2.1
bouffalolab 1.0.5

[01:24:45.738] - Serial port is COM13
[01:24:45.738] - ==================================================
[01:24:45.740] - Program Start
[01:24:45.740] - ========= eflash loader cmd arguments =========
[01:24:45.742] - serial port is COM13
[01:24:45.742] - chiptype: bl616
[01:24:45.742] - cpu_reset=False
[01:24:45.760] - com speed: 2000000
[01:24:45.760] - ========= Interface is uart =========
[01:24:45.760] - Bootrom load
[01:24:45.760] - ========= get_boot_info =========
[01:24:45.760] - ========= image get bootinfo =========
[01:24:46.036] - tx rx and power off, press the machine!
[01:24:46.036] - cutoff time is 0.05
[01:24:46.097] - power on tx and rx
[01:24:47.091] - reset cnt: 0, reset hold: 0.05, shake hand delay: 0.1
[01:24:47.091] - clean buf
[01:24:47.093] - send sync
[01:24:47.324] - ack is b'4f4b'
[01:24:47.324] - shake hand success
[01:24:49.844] - ack is b''
[01:24:49.844] - not enough values to unpack (expected 2, got 0)
[01:24:49.844] - {"ErrorCode": "0003","ErrorMsg":"BFLB LOAD HELP BIN FAIL"}
[01:24:49.845] - Burn Retry
[01:24:49.845] - Burn return with retry fail

握手成功后 烧写失败有遇见过吗？

点击烧录按钮后，长按IO2，当出现白色字体再按EN键保持1秒，最后出现橙色字体【All success】后再松开IO2.